TS 248/TS 260/TS 150

    Spécifications techniques


    Workpiece touch probe

    TS 248

    TS 260

    TS 150

    Probe accuracy

    ±5 µm with use of the standard stylus T404

    Probe repeatability

    Repeated probing from
    one direction

    2 s 1 μm at a probing velocity of 1 m/min

    Typical values:

    2 s 1 μm at a probing velocity of 3 m/min

    2 s 4 μm at a probing velocity of 5 m/min

    Deflection of probe contact

    5 mm in all directions (with stylus length L = 40 mm)

    Deflection force

    Axial: approx. 8 N (TS 248: approx. 4 N)

    Radial: approx. 1 N (TS 248: approx. 0.5 N)

    Probing velocity

    5 m/min

    Protection EN 60 529


    Operating temperature

    10 °C to 40 °C

    Storage temperature

    –20 °C to 70 °C

    Mass without taper shank

    ≈ 0.15 kg

    ≈ 0.1 kg


    • With taper shank1) (only with radial flange socket)
    • By M28x0.75 external thread
    • By coupling joint with M22x1 external thread
    • By M16x1 external thread to the mounting base
    • Contact on the mounting base
    • Axial cable outlet: M22x1 for fastening to the machine
    • Radial cable outlet: Fastened to the machine with four M3 screws

    Electrical connection*

    M12 flange socket, 8-pin; axial or radial

    Two-pole sliding contact on the mounting base

    Cable length

    25 m

    Voltage supply

    DC 15 V to 30 V/ 100 mA (without load)

    Connected via UTI 150

    Output signal2)

    • Trigger signals S and S (square-wave signal and its inverted signal)
    • Floating trigger output

    HTL signal levels2)

    UH 20 V at –IH 20 mA

    UL 2.8 V at IL 20 mA

    at DC 24 V rated voltage

    Signal transmission


    * Please select when ordering

    1) see Mounting page 18

    2) for TS 150 via UTI 150